Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

Board dimension

Based on DMP's Vortex processor / SoC this board is a full computer capable of running a standard Windows and Linux installation on the backpack of your robot.
3 posts • Page 1 of 1
Post a reply
3 posts • Page 1 of 1

Board dimension

Post by sascha » Thu Jul 02, 2009 2:12 pm

Post by sascha
Thu Jul 02, 2009 2:12 pm

Hi,

I would like to know the height of the Roboard (Rb-100). With the miniPCI interface on top, the board looks actually quite bulky (compared to some OMAP based boards).

Dimension according to Specification: 96 x 56 mm

Regards, Sascha
Hi,

I would like to know the height of the Roboard (Rb-100). With the miniPCI interface on top, the board looks actually quite bulky (compared to some OMAP based boards).

Dimension according to Specification: 96 x 56 mm

Regards, Sascha
sascha
Savvy Roboteer
Savvy Roboteer
User avatar
Posts: 29
Joined: Fri Nov 17, 2006 1:00 am
Top

Post by roboard » Fri Jul 03, 2009 4:47 am

Post by roboard
Fri Jul 03, 2009 4:47 am

the height of Roboard is around 21mm (include MiniPCI socket and part on back side)
Image
Image
the height of Roboard is around 21mm (include MiniPCI socket and part on back side)
Image
Image
roboard
Savvy Roboteer
Savvy Roboteer
Posts: 302
Joined: Fri Jul 03, 2009 4:44 am
Top

Post by sascha » Fri Jul 03, 2009 10:42 am

Post by sascha
Fri Jul 03, 2009 10:42 am

Not too bad. Thxs a lot.
Not too bad. Thxs a lot.
sascha
Savvy Roboteer
Savvy Roboteer
User avatar
Posts: 29
Joined: Fri Nov 17, 2006 1:00 am
Top

3 posts • Page 1 of 1
Post a reply
3 posts • Page 1 of 1
Return to Roboard - x86 Embedded Robot Board