Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

Information on Roboard supply

Based on DMP's Vortex processor / SoC this board is a full computer capable of running a standard Windows and Linux installation on the backpack of your robot.
2 posts • Page 1 of 1
Post a reply
2 posts • Page 1 of 1

Information on Roboard supply

Post by egnascimento » Fri Feb 19, 2010 9:04 pm

Post by egnascimento
Fri Feb 19, 2010 9:04 pm

Hi friends,
I have the following questions about RoBoard supply usage:

1. Is it safe to supply Roboard by all Vxx pins (from PWM connectors) instead J12? It seems to be directly connected and the current provided by 24 pins is compatible with the current supported by J12, isn't?

2. How much current can I use from +5V in J09 connector?


Thanks in advance,
Eduardo Garcia
Hi friends,
I have the following questions about RoBoard supply usage:

1. Is it safe to supply Roboard by all Vxx pins (from PWM connectors) instead J12? It seems to be directly connected and the current provided by 24 pins is compatible with the current supported by J12, isn't?

2. How much current can I use from +5V in J09 connector?


Thanks in advance,
Eduardo Garcia
egnascimento
Newbie
Newbie
Posts: 1
Joined: Fri Feb 19, 2010 8:48 pm
Top

Post by roboard » Mon Feb 22, 2010 2:32 am

Post by roboard
Mon Feb 22, 2010 2:32 am

1. Not suugest you input power from PWM Vxx.
2. the VCC of J9 can have to 1A
1. Not suugest you input power from PWM Vxx.
2. the VCC of J9 can have to 1A
roboard
Savvy Roboteer
Savvy Roboteer
Posts: 302
Joined: Fri Jul 03, 2009 4:44 am
Top

2 posts • Page 1 of 1
Post a reply
2 posts • Page 1 of 1
Return to Roboard - x86 Embedded Robot Board