Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

PWM power question

Based on DMP's Vortex processor / SoC this board is a full computer capable of running a standard Windows and Linux installation on the backpack of your robot.
3 posts • Page 1 of 1
Post a reply
3 posts • Page 1 of 1

PWM power question

Post by Sazabi » Mon May 10, 2010 7:55 am

Post by Sazabi
Mon May 10, 2010 7:55 am

Hi there!
Could I separate pwm power input from board power input on RB-100? Is there any other ways except of buying RB-110?)
Hi there!
Could I separate pwm power input from board power input on RB-100? Is there any other ways except of buying RB-110?)
Sazabi
Savvy Roboteer
Savvy Roboteer
Posts: 73
Joined: Mon Jan 07, 2008 8:57 am
Top

Post by Chaosmann » Mon May 10, 2010 4:49 pm

Post by Chaosmann
Mon May 10, 2010 4:49 pm

Hi,
you can use something like this:
http://servocity.com/html/servo_power_boards.html

Greetings
Daniel
Hi,
you can use something like this:
http://servocity.com/html/servo_power_boards.html

Greetings
Daniel
Chaosmann
Robot Builder
Robot Builder
Posts: 16
Joined: Wed Dec 09, 2009 3:43 am
Top

Post by Sazabi » Fri May 14, 2010 9:31 pm

Post by Sazabi
Fri May 14, 2010 9:31 pm

Nice thing! Thanks!
Nice thing! Thanks!
Sazabi
Savvy Roboteer
Savvy Roboteer
Posts: 73
Joined: Mon Jan 07, 2008 8:57 am
Top

3 posts • Page 1 of 1
Post a reply
3 posts • Page 1 of 1
Return to Roboard - x86 Embedded Robot Board