Roboard rb-100 with no power

[theadm]

Hi All,

I have a problem, my rb-100 wont turn on.

I had it working fine, booting into x-linux, then I attempted to get the remote serial working. I got it working, but had set the speed to 9600. Previously I had disabled the USB in BIOS. I then set the speed to 115200, and restarted it. I could not get it to work at 115200, so I tried to revert it back (which I could not). I thought - oh well there is the BIOS battery, maybe if I remove that it will reset the BIOS (rather than using the END key as I couldn't get it to work because I had disabled the USB via BIOS). I prodded the battery to see how it was connected, realising it was soldered on, I left it alone. I then reconnected the power adapter in which the rb-100 would not boot (no red light).

Can anyone give me any suggestions to try?

I have also emailed tech support, just like 2 minutes ago, so I will see what they have to say as well.

Thanks in advance ...

[roboard]

Hi
if the RED led not light up, that mean there is not any power in, please check the power area (in back side near power plug) maybe some parts been removed