Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

RoBoard RB-110 weight and 3d model

Based on DMP's Vortex processor / SoC this board is a full computer capable of running a standard Windows and Linux installation on the backpack of your robot.
3 posts • Page 1 of 1
Post a reply
3 posts • Page 1 of 1

RoBoard RB-110 weight and 3d model

Post by exe_cutable » Tue Nov 09, 2010 5:54 pm

Post by exe_cutable
Tue Nov 09, 2010 5:54 pm

Hi,

Does anyone know where I can get the 3d model of the RoBoard RB-110?
Also the weight, center of mass, inertia matrix all data for a physical simulation of the board (attached to a robot) would be nice =)

Regards,
Jorge
Hi,

Does anyone know where I can get the 3d model of the RoBoard RB-110?
Also the weight, center of mass, inertia matrix all data for a physical simulation of the board (attached to a robot) would be nice =)

Regards,
Jorge
exe_cutable
Newbie
Newbie
Posts: 5
Joined: Tue Nov 09, 2010 5:49 pm
Top

Post by matt.stevenson » Wed Nov 10, 2010 3:07 am

Post by matt.stevenson
Wed Nov 10, 2010 3:07 am

On the website they list 96 x 56 mm and a weight of 40g You'll have to take the other measurements independently since the values will change depending on what you have connected and where.
On the website they list 96 x 56 mm and a weight of 40g You'll have to take the other measurements independently since the values will change depending on what you have connected and where.
matt.stevenson
Savvy Roboteer
Savvy Roboteer
Posts: 37
Joined: Thu Apr 29, 2010 9:29 pm
Top

Post by comds » Mon Mar 14, 2011 1:41 pm

Post by comds
Mon Mar 14, 2011 1:41 pm

I could not find a 3d model of any kind for any of the Roboard products. I made a very crude one for Solidworks 2007 for the RB-100. It is more just for spacing the parts around it then a real model. Will be adding detail to it as I get more spare time.
I could not find a 3d model of any kind for any of the Roboard products. I made a very crude one for Solidworks 2007 for the RB-100. It is more just for spacing the parts around it then a real model. Will be adding detail to it as I get more spare time.
comds
Robot Builder
Robot Builder
Posts: 14
Joined: Thu Mar 04, 2010 5:17 pm
Top

3 posts • Page 1 of 1
Post a reply
3 posts • Page 1 of 1
Return to Roboard - x86 Embedded Robot Board