Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

RM-G144 Module

Based on DMP's Vortex processor / SoC this board is a full computer capable of running a standard Windows and Linux installation on the backpack of your robot.
2 posts • Page 1 of 1
Post a reply
2 posts • Page 1 of 1

RM-G144 Module

Post by JavaRN » Fri Dec 10, 2010 1:32 pm

Post by JavaRN
Fri Dec 10, 2010 1:32 pm

I've just received the RM-G144 module and I am trying to connect it to Roboard 100, but I got a little confused with the wire connections on the Roboard side, the 5v and GND are ok, but still puzzled with the others, is it

SCL (GM) ---------> I2C_0SCL (pin 4) (Roboard)
SDA (GM)----------> I2C_0SDA (pin 6) (Roboard)
X(white) (GM) -------> ?????
X(Orange) (GM) ------> ?????

Any suggestions?
I've just received the RM-G144 module and I am trying to connect it to Roboard 100, but I got a little confused with the wire connections on the Roboard side, the 5v and GND are ok, but still puzzled with the others, is it

SCL (GM) ---------> I2C_0SCL (pin 4) (Roboard)
SDA (GM)----------> I2C_0SDA (pin 6) (Roboard)
X(white) (GM) -------> ?????
X(Orange) (GM) ------> ?????

Any suggestions?
F'dan il-passatemp ghandek bzonn zewg affarijiet - FLUS u HIN. Zewg affarijiet li huma skarsi hafna u li jien minnhom ghandi vera ftit!
JavaRN
Savvy Roboteer
Savvy Roboteer
User avatar
Posts: 282
Joined: Fri Mar 02, 2007 11:01 pm
Top

Re: RM-G144 Module

Post by roboard » Sat Dec 11, 2010 7:30 am

Post by roboard
Sat Dec 11, 2010 7:30 am

JavaRN wrote:..., but I got a little confused with the wire connections on the Roboard side, the 5v and GND are ok, but still puzzled with the others, is it

SCL (GM) ---------> I2C_0SCL (pin 4) (Roboard)
SDA (GM)----------> I2C_0SDA (pin 6) (Roboard)
X(white) (GM) -------> ?????
X(Orange) (GM) ------> ?????

Any suggestions?


Hi,

X(white) and X(Orange) are unused in RM-G144. :)
JavaRN wrote:..., but I got a little confused with the wire connections on the Roboard side, the 5v and GND are ok, but still puzzled with the others, is it

SCL (GM) ---------> I2C_0SCL (pin 4) (Roboard)
SDA (GM)----------> I2C_0SDA (pin 6) (Roboard)
X(white) (GM) -------> ?????
X(Orange) (GM) ------> ?????

Any suggestions?


Hi,

X(white) and X(Orange) are unused in RM-G144. :)
roboard
Savvy Roboteer
Savvy Roboteer
Posts: 302
Joined: Fri Jul 03, 2009 4:44 am
Top

2 posts • Page 1 of 1
Post a reply
2 posts • Page 1 of 1
Return to Roboard - x86 Embedded Robot Board