[Help]RM-G144 and RM-G145 sensors

[RoboFlop]

I have these two sensors to hook up to my RB-100 and there is a link to some sample code for these on the Roboard sales page on this site.

The link doesnt work however, and there is no mention of this code on the Roboard site.

Its quite a daunting feeling as I have no experience of I2C bus programming and am not quite sure where to start....I'll get there but as I'm sure you know, its easier with a map

The purpose of the post is in the hope that someone may of downloaded the code before the link went and is willing to mail it on to me.

Any help to get started with these appreciated. In my project I intend to use Robotis AX actuators and later some RX's but I'd like to get up and running and start reading some values in from these sensors...

[roboard]

I have these two sensors to hook up to my RB-100 and there is a link to some sample code for these on the Roboard sales page on this site.

The link doesnt work however, and there is no mention of this code on the Roboard site.

...

Hi,

you can find G144 & G145 sample codes on the official site:

http://www.roboard.com/G145.html

[RoboFlop]

Thanks for the fast reply and simple solution Roboard.

I couldnt see the link to that while I was mooching around the Roboard site but I guess I missed something blatantly obvious

...now lets see if I can get this figured out...

Have a great christmas.