Havimo 2.0 didn't work.
Havimo 2.0 didn't work.
by faris
Tue Feb 07, 2012 2:32 pm
I have a havimo 2 camera. One day, when I try the camera with cm-510 in bioloid premium, the camera is not working. I have repeat calibration using havimo GUI, but still will not work. I check in roboplus manager but does not appear ( usually appear id 100 - unknown) and the voltage regulator is hot .
anyone can help with this problem please ?
I apologize for my bad english. Thanks in advance
anyone can help with this problem please ?
I apologize for my bad english. Thanks in advance
by hamid_m
Wed Feb 08, 2012 4:10 pm
Hi Faris,
A hot regulator does not have a good meaning. It shows a hardware defect. It may be in the camera chip (as it is more sensitive) or in the microcontroller.
The probable cause for that is a short circuit on the PCB. It may have touched a metallic surface.
I suggest using a plastic case to avoid such damages.
Best regards,
Hamid.
A hot regulator does not have a good meaning. It shows a hardware defect. It may be in the camera chip (as it is more sensitive) or in the microcontroller.
The probable cause for that is a short circuit on the PCB. It may have touched a metallic surface.
I suggest using a plastic case to avoid such damages.
Best regards,
Hamid.
