Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

786ICS vs 784ICS ?

KHR-1, KHR-2HV, KHR-3HV, ICS servos, RCB controllers and other Kondo products
3 posts • Page 1 of 1
Post a reply
3 posts • Page 1 of 1

786ICS vs 784ICS ?

Post by Guest » Thu Jan 19, 2006 5:19 am

Post by Guest
Thu Jan 19, 2006 5:19 am

Hello,
Anyone know the technical differences between the KRS 786ICS servos and the 784ICS servos.
I have looked around a little and did not find any difference in any of the parameters.
Thanks
Hello,
Anyone know the technical differences between the KRS 786ICS servos and the 784ICS servos.
I have looked around a little and did not find any difference in any of the parameters.
Thanks
Guest
Top

Post by Guest » Sun Jan 22, 2006 3:55 pm

Post by Guest
Sun Jan 22, 2006 3:55 pm

AFAIK there wasn't any physical or mechanical difference. 786 has a new firmware and also seems like they have resolved the braking-solder-points problem that occured in the 784 and doesn't any more.
AFAIK there wasn't any physical or mechanical difference. 786 has a new firmware and also seems like they have resolved the braking-solder-points problem that occured in the 784 and doesn't any more.
Guest
Top

Post by Guest » Mon Jan 23, 2006 4:37 am

Post by Guest
Mon Jan 23, 2006 4:37 am

Thanks for the info. Any ideas on what the new firmware addressed?
Thanks for the info. Any ideas on what the new firmware addressed?
Guest
Top

3 posts • Page 1 of 1
Post a reply
3 posts • Page 1 of 1
Return to KHR-1, KHR-2HV, KHR3-HV & Kondo