KBT-1
KBT-1
by Sailbot
Thu Dec 25, 2014 9:39 pm
I have setup a KHR-3HV robot and am able to communicate with it using H2H v4.
I have installed the KBT-1 bluetooth board and wired it as in the manual, using the splitter cable to connect to the SIO port and the "power" port on the KBT-1. I have used the red cable to connect from the comm port to the COM port on the RCB-4 (I unplugged the usb cable connector, and used the same set of pins for the KBT-1 connection - not sure if I can use another set of pins and have both the usb connector and the KBT-1 both plugged into the com port - this is Question 1).
I installed the Logitec Bluetooth dongle that I purchased with the robot and loaded the software. I can see the KBT-1 (pair with it), and assign a com port.
However, the light on the KBT-1 board stays blinking slowly red, and the H2H says it cannot communicate with the port when I select it.
I have been at this for quite a while now without getting any further. Any help?
Thanks,
Chris
I have installed the KBT-1 bluetooth board and wired it as in the manual, using the splitter cable to connect to the SIO port and the "power" port on the KBT-1. I have used the red cable to connect from the comm port to the COM port on the RCB-4 (I unplugged the usb cable connector, and used the same set of pins for the KBT-1 connection - not sure if I can use another set of pins and have both the usb connector and the KBT-1 both plugged into the com port - this is Question 1).
I installed the Logitec Bluetooth dongle that I purchased with the robot and loaded the software. I can see the KBT-1 (pair with it), and assign a com port.
However, the light on the KBT-1 board stays blinking slowly red, and the H2H says it cannot communicate with the port when I select it.
I have been at this for quite a while now without getting any further. Any help?
Thanks,
Chris
