RCB3HV Ver. 1.1a and 1.1 ?

[Ray]

Hi,

I wish to make an enquiry:

Recently, it seem the newest version of RCB3HV ( Version 1.1 ) had some problem and Kondo have introduced a new Version 1.1a.

Can any body know what is the problem of Ver.1.1 ?



Thanks a lot for information.

Ray

[tempusmaster]

Hi,
I wish to make an enquiry:
Recently, it seem the newest version of RCB3HV ( Version 1.1 ) had some problem and Kondo have introduced a new Version 1.1a.
Can any body know what is the problem of Ver.1.1 ?
Thanks a lot for information.
Ray

Ray,

I'll ask around and see what I can find out.

Do you plan on upgrading the firmware? The only additional functionality over the earlier version is support of the Kyosho 32 sensor board, so I was planning to hold off upgrading my RCB3's until I get one of the sensor boards.

[Ray]

Hi, tempusmaster,

Just want to build a full metal KHR2. I bought it during travel in Japan.
It is of version 1.10 but it seem to be have problem published in Kondo web site.

I use the Chest extension of KHR1,
More higher hight with one more servo length makes my new KHR2 very unstable ( easy to side fall, even equipped with 2 gyros)

please tell me the news of the version 1.1a if you know

Thanks!

[tempusmaster]

Just want to build a full metal KHR2. I bought it during travel in Japan.

Sounds great! Be sure to post some photos when you get a chance.

It is of version 1.10 but it seem to be have problem published in Kondo web site.

Yes - that's what it says, but unfortunately it doesn't say anything about what the problem was.
It's probably something minor, but it's hard to tell. I'll check around and see what I can find out.

I use the Chest extension of KHR1,
More higher hight with one more servo length makes my new KHR2 very unstable ( easy to side fall, even equipped with 2 gyros)

Well, you have to make it mechanically and dynamically stable without the gyros, then turn them on for correction. If it isn't stable without them, then they will only make it worse.

please tell me the news of the version 1.1a if you know
Thanks!

Of course! It may take a while though.