KHR-1HV

[grasshopper]

Hi,
I have a question. I finally build the robot a couple days back, however, I have 2 pieces left and really dont know where they go. I looked at the manual for both khr-2HV and khr-1HV but could not find anything about them. I have the picture can be found at
https://www.kopropo.co.jp/cgi-bin/Eshop ... 231%83T%81[%83{%83u%83%89%83P%83b%83gE
Any feedback is much appreciated

[ries]

Hi Grasshopper, they are not needed for your KHR-1HV.
Maybe they can be used instead of the plastic cover of the two servo's, but i don't know for sure.

But anyway they are not needed for your robot.

[plingboot]

i asked the same question a few weeks back - they're supplied so you can add an extra servo to each arm - for greater dexterity. But this does make it look a bit odd.

[grasshopper]

That makes me feel a lot better, thank you for the reply. It was really frustrating not knowing if what you did was in fact the right thing to do