KRC-3 to Low Speed Port
by Hotproceed2
Fri Mar 13, 2009 11:25 am
Hi
It moves successive while you push the button as follows when you make a motion.
1. Open the DATADlg and change the number1 of Controller input.
2. Set the motion as follows the picture and change the number1 in “Set the number in comparing resistor” of SET1.
3. Set CMP1 to “Jump the cotton input equals the comparing resistor”.
It moves successive while you push the button as follows when you make a motion.
1. Open the DATADlg and change the number1 of Controller input.
2. Set the motion as follows the picture and change the number1 in “Set the number in comparing resistor” of SET1.
3. Set CMP1 to “Jump the cotton input equals the comparing resistor”.
