KHR-1 short of parts
KHR-1 short of parts
by onesandzeros
Wed May 10, 2006 3:42 am
hey guys
iam new here, got my khr-1 assembled a few days ago, unfortunately i encountered some minor hardware issues.
My kit came with 9 screws short, and a whole lot of washers short.
Does anyone know where i could possibly find washers of this size?
Also iam going to need a charger, my battery only last like 10 mins or so. if it says 6.5 v and 800mah, will this be fine, or is the mah too high?
any help will be greatly appreciated.
iam new here, got my khr-1 assembled a few days ago, unfortunately i encountered some minor hardware issues.
My kit came with 9 screws short, and a whole lot of washers short.
Does anyone know where i could possibly find washers of this size?
Also iam going to need a charger, my battery only last like 10 mins or so. if it says 6.5 v and 800mah, will this be fine, or is the mah too high?
any help will be greatly appreciated.
by limor
Wed May 10, 2006 9:15 am
Hi Onesandzeros,
Some people make the mistake of placing all 3 screws/washers on all hones instead of 2 as instructed in the manual. Please check that first.
the 800mah battery should last at least 20-30 minutes.
Check previous posting about battery charging. It may also be a good idea to get a NiMH 6V 1100mAh battery and a good charger.
Some people make the mistake of placing all 3 screws/washers on all hones instead of 2 as instructed in the manual. Please check that first.
the 800mah battery should last at least 20-30 minutes.
Check previous posting about battery charging. It may also be a good idea to get a NiMH 6V 1100mAh battery and a good charger.
by onesandzeros
Wed May 10, 2006 7:43 pm
hey limor
thanks alot for the reply.
i removed the washers from the middle screw of the hone.
I have enough washers now, thanks.
As for battery, i think i might just try and get power supply to him
iv been looking at car battery chargers.
Closest one i found is 6v 15amps.
Iam still trying to see if i kan get something with 12amps locally.
thanks alot for the reply.
i removed the washers from the middle screw of the hone.
I have enough washers now, thanks.
As for battery, i think i might just try and get power supply to him
iv been looking at car battery chargers.
Closest one i found is 6v 15amps.
Iam still trying to see if i kan get something with 12amps locally.