Servo's
Servo's
by Trebor
Sat May 27, 2006 12:45 am
Hello,
I fried 9 servos in my Kondo Robot a while back which I posted. I am now ready to purchase replacements. I see that their are other options besides the direct replacment. I have KRS 786 ICS Red servos. Can I mix the HV with my current servos? What differences would I expect to see? Will the Gyro I purchased work with the new servos?
I fried 9 servos in my Kondo Robot a while back which I posted. I am now ready to purchase replacements. I see that their are other options besides the direct replacment. I have KRS 786 ICS Red servos. Can I mix the HV with my current servos? What differences would I expect to see? Will the Gyro I purchased work with the new servos?
by limor
Sat May 27, 2006 2:27 am
Hi Trebor,
The controler board that you have, RCB-1, is designed to work at 6V hence it will not work with the High-Voltage servos (788). And the same is true for RCB-3 controller working with 10V input, will fry the 786 servos.
I don't think the KRG-2 gyro will work with the HV servos but I'll try to find out for sure.
How did you fry all 9 servos?
You may either replace 9 x 786 servos, or you can get the HV upgrade kit for the KHR-1, or just order a brand new KHR-2HV.. (all options available at http://robosavvy.com/store )
The controler board that you have, RCB-1, is designed to work at 6V hence it will not work with the High-Voltage servos (788). And the same is true for RCB-3 controller working with 10V input, will fry the 786 servos.
I don't think the KRG-2 gyro will work with the HV servos but I'll try to find out for sure.
How did you fry all 9 servos?
You may either replace 9 x 786 servos, or you can get the HV upgrade kit for the KHR-1, or just order a brand new KHR-2HV.. (all options available at http://robosavvy.com/store )
