Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

High Speed Serial wiring...

KHR-1, KHR-2HV, KHR-3HV, ICS servos, RCB controllers and other Kondo products
2 posts • Page 1 of 1
Post a reply
2 posts • Page 1 of 1

High Speed Serial wiring...

Post by shsan » Fri Aug 11, 2006 9:41 am

Post by shsan
Fri Aug 11, 2006 9:41 am

Just a stupid question,

I want to connect the high speed serial link to a Bluetooth module for some tests. However i can't find anywhere the correspondance between the color of the cable and the functions. My guess is that here is TX,RX and GND.

I am pretty sure i saw it somewhere in one of the pdf but i can't find it anymore.

Any information would be very welcome :)

Thanks.
Just a stupid question,

I want to connect the high speed serial link to a Bluetooth module for some tests. However i can't find anywhere the correspondance between the color of the cable and the functions. My guess is that here is TX,RX and GND.

I am pretty sure i saw it somewhere in one of the pdf but i can't find it anymore.

Any information would be very welcome :)

Thanks.
shsan
Savvy Roboteer
Savvy Roboteer
Posts: 87
Joined: Sat Jul 29, 2006 1:00 am
Location: Utsunomiya, Japan
Top

Post by shsan » Fri Aug 11, 2006 10:02 am

Post by shsan
Fri Aug 11, 2006 10:02 am

Ok forget about it, just found it in this forum under General/Bluetooth Moduel 2 thread.

Thanks.
Ok forget about it, just found it in this forum under General/Bluetooth Moduel 2 thread.

Thanks.
shsan
Savvy Roboteer
Savvy Roboteer
Posts: 87
Joined: Sat Jul 29, 2006 1:00 am
Location: Utsunomiya, Japan
Top

2 posts • Page 1 of 1
Post a reply
2 posts • Page 1 of 1
Return to KHR-1, KHR-2HV, KHR3-HV & Kondo