Trimming
Trimming
by RedFoxDude
Sun Aug 13, 2006 5:53 pm
Does anyone know how to trim the servo postions (is that what it's called?) I zeroed my KHR-2 just fine, but the zero positions are slightly off. I know this because the servos have the correct flexibility. I couldn't get the brackets on quite straight because of the notches on the servo axle and brackets.
Thanks,
Red
Thanks,
Red
by noDNA
Wed Aug 16, 2006 9:21 am
RedFoxDude,
Open the window with the yellow BIRD icon.
Change servo positions as needed.
Go to POS Editor, drag one POS icon into the Editor plane
Double click this POS icon
Click the channel you want to save with right mouse
This opens a dialogue. The second last enty (long word) is save.
As usual there is no confirm statement, but it does save.
regards
noDNA
Open the window with the yellow BIRD icon.
Change servo positions as needed.
Go to POS Editor, drag one POS icon into the Editor plane
Double click this POS icon
Click the channel you want to save with right mouse
This opens a dialogue. The second last enty (long word) is save.
As usual there is no confirm statement, but it does save.
regards
noDNA
