Servos on both lower arms did not response (ID4) KHR-3HV

[taylor]

Is me again! It seem not much people on this forum.

By the way, I wonder if anyone can help me on this issue? I installed 22 servos +RAS-2 +KRG-4 +3AD. Everything seems OK as I can use the remote to control different motions.

However, servos (ID4) on both lower arms did not response. It did not response to HTH4 too. Other servos is working OK.

[Thex1138]

Just wondering did you install the software package from the servo extension pack?

It seems a bit different but because it is in Japanese there is not much of a way to know...

When I plugged my battery in to power up it also seemed not to find them...

I have to wait over night to recharge again...

When I switch to LiPo it will be better!

/Thex

[taylor]

Thank you!

I did not find any useful software in the CD. I download HTH4 ver 1.1 from Internet. and use the standard project (Hello_KHR3).

You have to tick the box on the left to enable the ext. servos.

If you get everything work, please let me know.