KHR-2HV USB WIRELESS

[fatman]

i am trying to figure out what all the leads that came with the USB tx/rx
there is one lead with just a signal and earth wire, another with earth and positive and the final one combines two leads into one.

on the processor board there is an input for rx
i assume thats for the reciever
aside from installiing drivers and plugging rx in, is there anything else i have to do to enable the wireless?

from what i can gather the extra leads may be for interfacing into the KHR-1 processor boards but am unsure.

btw i have installed drivers and pluged rx into board - nothing
yes i have confirmed that i was using the correct com port
i am not sure if i should run the remove all driver script and reinstall wireless drivers only? i have both ports and they seem ok, but only serial one from computer seems to work.
maybe something software side?

all help as always greatly appreciated

[animetown9]

I have tried the same thing. It doesn't work.
Do we need an extra battery to plug into the reciever or not?
I have tried uninstall and install many time still doesn't work.