KHR2 assembly question...

[pinoc]

Hi all, I am a newbie.
Assembling it right now. The battery is charging!
2 questions, on page 29 assembly manual,
1) why need to do "(3) movable range" by hand?
To make sure the servo can turn? I don't quite get it.

2) when setting the starting point for servos,
do you simply plug in each servo into Ch1 on the board?
ie no need to match the exact channel number on the board

Thank you!

[RedFoxDude]

1) That is the part in which you make sure that the servo has the correct range of movement. (Same as checking if it is zeroed correctly.)

Also, (2) it does not matter where you plug it in as long as you zero it correctly.

Red

[pinoc]

Ok thanks, I feel more confident now.