Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

KHR2 assembly question...

KHR-1, KHR-2HV, KHR-3HV, ICS servos, RCB controllers and other Kondo products
3 postsPage 1 of 1
3 postsPage 1 of 1

KHR2 assembly question...

Post by pinoc » Sun Oct 01, 2006 2:24 am

Post by pinoc
Sun Oct 01, 2006 2:24 am

Hi all, I am a newbie.
Assembling it right now. The battery is charging!
2 questions, on page 29 assembly manual,
1) why need to do "(3) movable range" by hand?
To make sure the servo can turn? I don't quite get it.

2) when setting the starting point for servos,
do you simply plug in each servo into Ch1 on the board?
ie no need to match the exact channel number on the board

Thank you! :)
Hi all, I am a newbie.
Assembling it right now. The battery is charging!
2 questions, on page 29 assembly manual,
1) why need to do "(3) movable range" by hand?
To make sure the servo can turn? I don't quite get it.

2) when setting the starting point for servos,
do you simply plug in each servo into Ch1 on the board?
ie no need to match the exact channel number on the board

Thank you! :)
pinoc
Robot Builder
Robot Builder
User avatar
Posts: 8
Joined: Sat Sep 30, 2006 1:00 am

Post by RedFoxDude » Sun Oct 01, 2006 3:51 am

Post by RedFoxDude
Sun Oct 01, 2006 3:51 am

1) That is the part in which you make sure that the servo has the correct range of movement. (Same as checking if it is zeroed correctly.)

Also, (2) it does not matter where you plug it in as long as you zero it correctly.

Red
1) That is the part in which you make sure that the servo has the correct range of movement. (Same as checking if it is zeroed correctly.)

Also, (2) it does not matter where you plug it in as long as you zero it correctly.

Red
RedFoxDude
Savvy Roboteer
Savvy Roboteer
User avatar
Posts: 58
Joined: Mon Jul 24, 2006 1:00 am
Location: Oakland, CA

Post by pinoc » Sun Oct 01, 2006 4:03 am

Post by pinoc
Sun Oct 01, 2006 4:03 am

Ok thanks, I feel more confident now.
Ok thanks, I feel more confident now.
pinoc
Robot Builder
Robot Builder
User avatar
Posts: 8
Joined: Sat Sep 30, 2006 1:00 am


3 postsPage 1 of 1
3 postsPage 1 of 1