RCB-1 signal levels, pinouts
RCB-1 signal levels, pinouts
by apeiron
Fri Oct 27, 2006 7:50 pm
Hi all,
i'm trying to interface the rcb-1 boards with an atmel atmega128 which has some sensors connected to it. anyone did that before?
does the serial cable supplied with the khr-1 actually convert the rs232 signals to ttl level e.g. with a MAX232, or is it just a "sub-d9 to 3pin"-adapter ?
Havent found the pinouts of the board either - so if someone could point them out for me i'd be very thankful.
thanks in advance,
soeren
i'm trying to interface the rcb-1 boards with an atmel atmega128 which has some sensors connected to it. anyone did that before?
does the serial cable supplied with the khr-1 actually convert the rs232 signals to ttl level e.g. with a MAX232, or is it just a "sub-d9 to 3pin"-adapter ?
Havent found the pinouts of the board either - so if someone could point them out for me i'd be very thankful.
thanks in advance,
soeren
