Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

servos not working

KHR-1, KHR-2HV, KHR-3HV, ICS servos, RCB controllers and other Kondo products
1 post • Page 1 of 1
Post a reply
1 post • Page 1 of 1

servos not working

Post by amsibl » Tue Sep 03, 2013 5:17 pm

Post by amsibl
Tue Sep 03, 2013 5:17 pm

i have a pre-built khr-1hv. i have been programming using hth 3. i have been making adjustments to the walking forward program and am finding two servos, #11 (left leg in and out) and #17 (right leg in and out) are not responding to adjustments. they are connected properly and even in a test mode do not respond. they work in pre-programs but are not open to my adjusting! any ideas please? thank you
i have a pre-built khr-1hv. i have been programming using hth 3. i have been making adjustments to the walking forward program and am finding two servos, #11 (left leg in and out) and #17 (right leg in and out) are not responding to adjustments. they are connected properly and even in a test mode do not respond. they work in pre-programs but are not open to my adjusting! any ideas please? thank you
amsibl
Newbie
Newbie
Posts: 5
Joined: Fri Jun 28, 2013 8:50 pm
Top
1 post • Page 1 of 1
Post a reply
1 post • Page 1 of 1
Return to KHR-1, KHR-2HV, KHR3-HV & Kondo