Zig2serial Problem

[nepotech]

Hi All,

I have zig2serial,zig100 and zig110. I connect the zig110 to atmega16, ang zig100+zig2serial in PC.
I sending a data from zig110 to zig100+zig2serial. I see the indicator RX in zig2serial is blink, but i can't read the data
from my computer. I using C# code program to reading zig2serial data.

Any solution for this problem?
Please help me.

Thanks for all.

[siempre.aprendiendo]

Do you receive absolutely nothing?
There is no data to read? (serialPort.BytesToRead)

The divide and conquer tactic,
- create the most simple PC program to receive data, so you are sending data correctly (CM-5xx->PC Test code)
- cerate the most simple CM-5xx program to send data, testing that you are receiving data correctly (CM-5xx Test code->PC)

- If all works you could continue adding code step to step until it fails or your initial program works.
- If all fails, probably you should learn a little more about it, search articles, books, tutorials, examples... you may find some help at http://softwaresouls.com/softwaresouls/tag/serial-port/
- If a part fails you can focus in that part to find and fix the problem

Hope it helps

[nepotech]

Thanks for your reply siempre.

I have read data from zig2serial using c#. i found my problem. the problem is switch usb2dinamyxel (rs232 switch) is bad contact. i repair it, and i found my solution.