Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

how to validate that the fillament is less than 2mm diameter

3D printers, custom projects and parts for enhancing your robot or creating one from scratch.
1 post • Page 1 of 1
Post a reply
1 post • Page 1 of 1

how to validate that the fillament is less than 2mm diameter

Post by limor » Fri Feb 22, 2013 4:16 pm

Post by limor
Fri Feb 22, 2013 4:16 pm

phpBB [media]



just make it pass through a 2mm hole made in aluminum sheet.
If it blocks then we just push it hard until it conforms to 2mm.
if the filament is more than 2mm, the extruder may block.
phpBB [media]



just make it pass through a 2mm hole made in aluminum sheet.
If it blocks then we just push it hard until it conforms to 2mm.
if the filament is more than 2mm, the extruder may block.
limor
Savvy Roboteer
Savvy Roboteer
User avatar
Posts: 1845
Joined: Mon Oct 11, 2004 1:00 am
Location: London, UK
Top
1 post • Page 1 of 1
Post a reply
1 post • Page 1 of 1
Return to 3D Printing for Robotics