Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

Cable Wear Solve

Hitec robotics including ROBONOVA humanoid, HSR-8498HB servos, MR C-3024 Controllers and RoboBasic
1 post • Page 1 of 1
Post a reply
1 post • Page 1 of 1

Cable Wear Solve

Post by DirtyRoboto » Tue Jan 30, 2007 12:48 am

Post by DirtyRoboto
Tue Jan 30, 2007 12:48 am

A surround of silicone gel on the prone points of the cable will give a longer life and a visible warning of wear.
I used a hotmelt glue gun to test out on a prone cable and it has held up so far.
Also I am going to try heatshrink the next time I strip the board.

Marcus.
A surround of silicone gel on the prone points of the cable will give a longer life and a visible warning of wear.
I used a hotmelt glue gun to test out on a prone cable and it has held up so far.
Also I am going to try heatshrink the next time I strip the board.

Marcus.
DirtyRoboto
Savvy Roboteer
Savvy Roboteer
User avatar
Posts: 412
Joined: Tue Sep 19, 2006 1:00 am
Location: London
Top
1 post • Page 1 of 1
Post a reply
1 post • Page 1 of 1
Return to ROBONOVA-I & Hitec