Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

Help

Hitec robotics including ROBONOVA humanoid, HSR-8498HB servos, MR C-3024 Controllers and RoboBasic
1 post • Page 1 of 1
Post a reply
1 post • Page 1 of 1

Help

Post by JavaRN » Thu Mar 22, 2007 12:13 am

Post by JavaRN
Thu Mar 22, 2007 12:13 am

I was mounting my newly arrived robonova and everything was ok until I started mounting the feet, I really got mixed up and I couldn't make heads or tails from the manual's diagram, so I turned to page 10 and I installed the servos following the diagram on that page, however the numbers on the servos did not match exactly so I had to turn the numbers so that they match, from example from 2 I made it point to 4. Did I do something wrong? if I did what do you suggest, please help.

Thanks
I was mounting my newly arrived robonova and everything was ok until I started mounting the feet, I really got mixed up and I couldn't make heads or tails from the manual's diagram, so I turned to page 10 and I installed the servos following the diagram on that page, however the numbers on the servos did not match exactly so I had to turn the numbers so that they match, from example from 2 I made it point to 4. Did I do something wrong? if I did what do you suggest, please help.

Thanks
JavaRN
Savvy Roboteer
Savvy Roboteer
User avatar
Posts: 282
Joined: Fri Mar 02, 2007 11:01 pm
Top
1 post • Page 1 of 1
Post a reply
1 post • Page 1 of 1
Return to ROBONOVA-I & Hitec