Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

Can RN-1's servo ports control standard hobby servos?

Hitec robotics including ROBONOVA humanoid, HSR-8498HB servos, MR C-3024 Controllers and RoboBasic
3 posts • Page 1 of 1
Post a reply
3 posts • Page 1 of 1

Can RN-1's servo ports control standard hobby servos?

Post by FuzzBot » Fri Jun 01, 2007 7:19 pm

Post by FuzzBot
Fri Jun 01, 2007 7:19 pm

What I'm really asking is this: Do the 3024's servo ports send out a standard PWM control signal or serial commands? I want to use some of the spare servo ports to control DC motor controllers. Has anybody done this?
What I'm really asking is this: Do the 3024's servo ports send out a standard PWM control signal or serial commands? I want to use some of the spare servo ports to control DC motor controllers. Has anybody done this?
FuzzBot
Newbie
Newbie
Posts: 2
Joined: Thu Apr 12, 2007 7:49 pm
Top

Post by i-Bot » Fri Jun 01, 2007 8:18 pm

Post by i-Bot
Fri Jun 01, 2007 8:18 pm

They are standard PWM. though the range of pulse length is a bit wider, adjust the position values to suit your servos or controllers.
They are standard PWM. though the range of pulse length is a bit wider, adjust the position values to suit your servos or controllers.
i-Bot
Savvy Roboteer
Savvy Roboteer
User avatar
Posts: 1142
Joined: Wed May 17, 2006 1:00 am
Top

Post by FuzzBot » Fri Jun 01, 2007 9:12 pm

Post by FuzzBot
Fri Jun 01, 2007 9:12 pm

A wide range is perfect for controlling motors. Perfect! Thanks for the info.
A wide range is perfect for controlling motors. Perfect! Thanks for the info.
FuzzBot
Newbie
Newbie
Posts: 2
Joined: Thu Apr 12, 2007 7:49 pm
Top

3 posts • Page 1 of 1
Post a reply
3 posts • Page 1 of 1
Return to ROBONOVA-I & Hitec