Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

ETX AND ERX Baud rate

Hitec robotics including ROBONOVA humanoid, HSR-8498HB servos, MR C-3024 Controllers and RoboBasic
3 posts • Page 1 of 1
Post a reply
3 posts • Page 1 of 1

ETX AND ERX Baud rate

Post by viper1 » Fri Jun 01, 2007 7:31 pm

Post by viper1
Fri Jun 01, 2007 7:31 pm

What is the set Baud Rate for the MR3024 ERX and TRX Lines Is it 2400? And can it be changed?? :?
What is the set Baud Rate for the MR3024 ERX and TRX Lines Is it 2400? And can it be changed?? :?
viper1
Savvy Roboteer
Savvy Roboteer
Posts: 37
Joined: Thu May 10, 2007 2:55 pm
Top

Post by i-Bot » Fri Jun 01, 2007 8:26 pm

Post by i-Bot
Fri Jun 01, 2007 8:26 pm

Setting the baud rate is part of the ETX and ERX commands in the range 2400 to 230400 baud. Check out the Robobasic command manual.
Setting the baud rate is part of the ETX and ERX commands in the range 2400 to 230400 baud. Check out the Robobasic command manual.
i-Bot
Savvy Roboteer
Savvy Roboteer
User avatar
Posts: 1142
Joined: Wed May 17, 2006 1:00 am
Top

Post by viper1 » Wed Jun 06, 2007 9:38 pm

Post by viper1
Wed Jun 06, 2007 9:38 pm

thanks i-bot got it all figured out.
thanks i-bot got it all figured out.
viper1
Savvy Roboteer
Savvy Roboteer
Posts: 37
Joined: Thu May 10, 2007 2:55 pm
Top

3 posts • Page 1 of 1
Post a reply
3 posts • Page 1 of 1
Return to ROBONOVA-I & Hitec