Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

Anybody know where I can get the pin config of MR-C3024

Hitec robotics including ROBONOVA humanoid, HSR-8498HB servos, MR C-3024 Controllers and RoboBasic
4 posts • Page 1 of 1
Post a reply
4 posts • Page 1 of 1

Anybody know where I can get the pin config of MR-C3024

Post by uthai » Wed Mar 08, 2006 4:47 am

Post by uthai
Wed Mar 08, 2006 4:47 am

Please, anyone know the pin description of MR-C3024 to download ? ETX, ERX,...
Please, anyone know the pin description of MR-C3024 to download ? ETX, ERX,...
uthai
Top

Post by RubikCube » Wed Mar 08, 2006 5:10 am

Post by RubikCube
Wed Mar 08, 2006 5:10 am

Send An EMail to Hitec RCD support they will send it to you.

http://www.hitecrobotics.com/contact/contact.htm
Send An EMail to Hitec RCD support they will send it to you.

http://www.hitecrobotics.com/contact/contact.htm
RubikCube
Robot Builder
Robot Builder
User avatar
Posts: 23
Joined: Mon Mar 06, 2006 1:00 am
Top

Post by subpilot » Wed Mar 08, 2006 8:07 am

Post by subpilot
Wed Mar 08, 2006 8:07 am

The manual (pg 42) has a picture showing the port locations. It's not great but it works. The headers are all wired with GND on the outboard side, PWR center and SIG on the most inboard pin.
The manual (pg 42) has a picture showing the port locations. It's not great but it works. The headers are all wired with GND on the outboard side, PWR center and SIG on the most inboard pin.
subpilot
Savvy Roboteer
Savvy Roboteer
User avatar
Posts: 146
Joined: Sat Feb 25, 2006 1:00 am
Location: Lake Arrowhead, Ca,USA
Top

Controller Pin diagram

Post by dshinsel » Wed Mar 29, 2006 7:12 am

Post by dshinsel
Wed Mar 29, 2006 7:12 am

Note that the top row of headers, the center pin is +5v, but the side headers have about +6v (unregulated battery voltage).

Also, I found this other diagram. It's got lots of data if you can figure it all out... :-)


http://www.hitecrobotics.com/info/downloads.htm


file is: MR-C3024 Specification: PDF (1MB)
Note that the top row of headers, the center pin is +5v, but the side headers have about +6v (unregulated battery voltage).

Also, I found this other diagram. It's got lots of data if you can figure it all out... :-)


http://www.hitecrobotics.com/info/downloads.htm


file is: MR-C3024 Specification: PDF (1MB)
dshinsel
Top

4 posts • Page 1 of 1
Post a reply
4 posts • Page 1 of 1
Return to ROBONOVA-I & Hitec