Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

Inside the gyro

Hitec robotics including ROBONOVA humanoid, HSR-8498HB servos, MR C-3024 Controllers and RoboBasic
2 posts • Page 1 of 1
Post a reply
2 posts • Page 1 of 1

Inside the gyro

Post by Voelker » Fri Oct 26, 2007 1:49 pm

Post by Voelker
Fri Oct 26, 2007 1:49 pm

Hi,

I have bought a gyro (GWS) for my robonova and i opened it to access the gain screw as the plastic case wasn't well aligned with it. During this operation i turned another screw in the case and i don't know what it is used for. I have no trouble to set up the gyro. Could someone help me to turn this scrw to its original setting.
Thanks
Hi,

I have bought a gyro (GWS) for my robonova and i opened it to access the gain screw as the plastic case wasn't well aligned with it. During this operation i turned another screw in the case and i don't know what it is used for. I have no trouble to set up the gyro. Could someone help me to turn this scrw to its original setting.
Thanks
Voelker
Savvy Roboteer
Savvy Roboteer
Posts: 85
Joined: Thu Sep 06, 2007 7:32 pm
Top

Post by aguiloco » Mon Oct 29, 2007 9:45 pm

Post by aguiloco
Mon Oct 29, 2007 9:45 pm

Hi, as I know, one screw trigger is for gain as you said, and the other one is for setup, you have to rotate it to make the LED light turn green.
Hi, as I know, one screw trigger is for gain as you said, and the other one is for setup, you have to rotate it to make the LED light turn green.
aguiloco
Savvy Roboteer
Savvy Roboteer
User avatar
Posts: 47
Joined: Fri Dec 01, 2006 1:00 am
Top

2 posts • Page 1 of 1
Post a reply
2 posts • Page 1 of 1
Return to ROBONOVA-I & Hitec