Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

Things to DO and NOT Do with your RN-!

Hitec robotics including ROBONOVA humanoid, HSR-8498HB servos, MR C-3024 Controllers and RoboBasic
16 posts • Page 2 of 2 • 1, 2
Post a reply
16 posts • Page 2 of 2 • 1, 2

what not to do

Post by engineer » Sat Mar 17, 2007 7:52 pm

Post by engineer
Sat Mar 17, 2007 7:52 pm

Hi guy's I've got the new spectrum Tx Rx for my rockcrawler the rf section does not allow any interference. I got a new notebook and bluetooth running for RN-! the B/T seems to work as well as the spectrum for control without interference and the codes from PEV, with a little tweaking for the individual robots, runs great. i've tried to use puppeteer but couldn't get connectivity. I have stuck some other routines into the mix and RN-! does fine except for left cartwheel but I think that RN's suffering from a weak servo. can't wait for the 5498's to start shipping. Welcome and good luck. 8)
Hi guy's I've got the new spectrum Tx Rx for my rockcrawler the rf section does not allow any interference. I got a new notebook and bluetooth running for RN-! the B/T seems to work as well as the spectrum for control without interference and the codes from PEV, with a little tweaking for the individual robots, runs great. i've tried to use puppeteer but couldn't get connectivity. I have stuck some other routines into the mix and RN-! does fine except for left cartwheel but I think that RN's suffering from a weak servo. can't wait for the 5498's to start shipping. Welcome and good luck. 8)
engineer
Savvy Roboteer
Savvy Roboteer
User avatar
Posts: 129
Joined: Wed Aug 09, 2006 1:00 am
Location: northern california
Top
Previous
16 posts • Page 2 of 2 • 1, 2
Post a reply
16 posts • Page 2 of 2 • 1, 2
Return to ROBONOVA-I & Hitec