HFP-10. Hitec Digital Servo Programmer
HFP-10. Hitec Digital Servo Programmer
by logicerror
Fri Dec 07, 2007 8:04 pm
Greetings everybody. I have a HFP-10 from Hitec, and I'm using it only to test digital servos.. The name says it can also program them.. What does that mean? Where could I find some documentation about programming servos with it, cause I've lost mine 
and will it work with servos other than Hitec?
Thanks.
and will it work with servos other than Hitec?
Thanks.
by i-Bot
Sat Dec 08, 2007 11:03 pm
The HFP-10 can test pretty much any analog or dogital servo, outputting a pulse of variable length.
The manual is here:
http://www.amerang-group.com/admin/modu ... HFP-10.pdf
It will program many Hitec Digital servos, but not those of other maufacturers. The Hitec servos it will program includes the HS5475 and the the HSR-5995TG. It is used by robot folks to increase the "out of the box" range from 180 degrees to 270 degrees.
It will not program NSR-8498HB, or the new HMI HSR servos from Hitec. For these use the free software and the serial cable from PC
The manual is here:
http://www.amerang-group.com/admin/modu ... HFP-10.pdf
It will program many Hitec Digital servos, but not those of other maufacturers. The Hitec servos it will program includes the HS5475 and the the HSR-5995TG. It is used by robot folks to increase the "out of the box" range from 180 degrees to 270 degrees.
It will not program NSR-8498HB, or the new HMI HSR servos from Hitec. For these use the free software and the serial cable from PC
