Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

Port IN /OUT connect and signal

Hitec robotics including ROBONOVA humanoid, HSR-8498HB servos, MR C-3024 Controllers and RoboBasic
1 post • Page 1 of 1
Post a reply
1 post • Page 1 of 1

Port IN /OUT connect and signal

Post by ayu » Fri Jan 11, 2008 4:57 am

Post by ayu
Fri Jan 11, 2008 4:57 am

Hi,all

In roboBASIC Command Instruction Manual V2.10 find the command about the Digital signal input and output command(page 5).


The command KEYIN (Receive analog keypad input.).

How about the keypad look like??

Have guys used the other commands to control RN-1??

How to connect and program write??Thanks a lot.
Hi,all

In roboBASIC Command Instruction Manual V2.10 find the command about the Digital signal input and output command(page 5).


The command KEYIN (Receive analog keypad input.).

How about the keypad look like??

Have guys used the other commands to control RN-1??

How to connect and program write??Thanks a lot.
ayu
Savvy Roboteer
Savvy Roboteer
Posts: 39
Joined: Wed Sep 26, 2007 3:28 pm
Top
1 post • Page 1 of 1
Post a reply
1 post • Page 1 of 1
Return to ROBONOVA-I & Hitec