Need working Overall Template Program

[tanasit]

Could anyone please post the wroking Overall Template Program?
Hi,

I need some help with my Robonova (got it yesterday).

First the Servo motor real time control box never pops up even though the cable is properly connected and works fine in the Roboscript!! (Windows XP)

Next when I reprogram the remote controller, all the command was gone but I finally got them back but the main red power button doesn't work like before and I couldn't find its code anywhere.

When I tried to compile the Overall template program, the Robobasic indicates several error:



SPEED i

Line 436 (error 42) speed only number or constant



GOTO AUTO

Line 9 (error 25) GOTO no exist used label name

I correct the first error by replacing the loop with full written codes (just as it shows in the separated "flying" code). But I can't figure out the error 25 which tells me that there is no AUTO sub routine.

Summary:

1. Why can't I get the Servo motor real time control box to pop up?

2. How to get the red power on button to work?

3. error 25 ???

4. Could anyone please post the working Overall Template Program?

Thank you,

[Guest]

Dude, sorry I am not familiar with your trouble but I can tell you where to find the Overall Template.

http://www.hitecrobotics.com/info/downloads.htm

[tanasit]

Dude, sorry I am not familiar with your trouble but I can tell you where to find the Overall Template.

http://www.hitecrobotics.com/info/downloads.htm

I already tried that and didn't work!!

[tanasit]

Hitec also provide the pushup code, but still with some error! I later found the fix and got it to work however.

[gsferrari]

Did you select the right controller? the right port?

[tanasit]

Did you select the right controller? the right port?

Yes because the roboscript works fine. I can slide the servo control panel and it works.

As of now, I manually insert each move using the Robo remocon and it works but the red on/off button on the controller doesn't work!

Too bad you can upload the code from the Robonova to your computer.

[Tohm]

Each program has its own port setup. Did you set the one up for robobasic?

[tanasit]

Each program has its own port setup. Did you set the one up for robobasic?

You are right!! The port was correct but the controler type was NOT. The default setting was MR-C3000 which caused all the error. Once I set it to MR-C3024, it works.

Thanks!!!

[gsferrari]

Each program has its own port setup. Did you set the one up for robobasic?

You are right!! The port was correct but the controler type was NOT. The default setting was MR-C3000 which caused all the error. Once I set it to MR-C3024, it works.

Thanks!!!

Sweet...glad it all worked out! HAVE FUN!!

[crmfghtr]

Hey this Tanasit from the old Aibonet days?

[tanasit]

great memory!!