MOVE24

[roboTT]

Guys,

as you probably know, i code RN-1 using C++ enviroment.

The :

Code: Select all

SerialPutc(hCom,0xE6);//move servo

is handy, but when there is a need to perform a move for a few servoes at once ( MOVE24 ) - 0xE6 ( servo position ) is not usefull.

For a move like:

Code: Select all

MOVE24  85,  71, 152,  91, 112,  60, 100,  40,  80,    ,    ,    , 100,  40,  80,    ,    ,    , 112,  76, 145,  93,  92,  60,

There is a need to start the movement at once for all servos in the command, and if i try to do the same with 0xE6 - waiting for each command to reply - the movement gets a little bit desynchronized - what is crucial when i perform i.e. Forward move.


Maybe you know, how to avoid / trick this out ?


Many thanks to you all !