Errors in the manual
Errors in the manual
by Richard
Sun Apr 23, 2006 9:32 am
I've noticed one or two errors in the manual as I've been building my RN.
On page 22, bottom left picture shows servo 3 connected to servo 4 and servo 1 connected to servo 2. Page 10 shows that 3 goes with 2 and 1 goes with 4. Which is correct?
On page 28, second picture from the bottom, shows servo 11 on the left and servo 12 on the right. If I line up the servos, with the black screws uppermost and the cables on the outside, 12 has to be on the left and 11 on the right!
Page 37, second to last photo calls up self tappers PH/T, these should be PH/M - machined bolts.
Are there any other errors?
On page 22, bottom left picture shows servo 3 connected to servo 4 and servo 1 connected to servo 2. Page 10 shows that 3 goes with 2 and 1 goes with 4. Which is correct?
On page 28, second picture from the bottom, shows servo 11 on the left and servo 12 on the right. If I line up the servos, with the black screws uppermost and the cables on the outside, 12 has to be on the left and 11 on the right!
Page 37, second to last photo calls up self tappers PH/T, these should be PH/M - machined bolts.
Are there any other errors?
by oliver_s
Sun Apr 23, 2006 11:49 am
Those all look right for errors.
Have a look at my site:
http://www.antweight.co.uk/robonova/index.htm
I tried to point out all the issues I came across. It was mostly the leg servos than annoyed me.
Have a look at my site:
http://www.antweight.co.uk/robonova/index.htm
I tried to point out all the issues I came across. It was mostly the leg servos than annoyed me.
