MR-C3024F and Robobasic 2.72
by NovaOne
Thu Apr 08, 2010 8:44 pm
Sazabi:
Thanks for the link ...I will try it.
i-bot:
It does seem likely that it may be the C3024 eeprom... ie it's only the code in the uController that I should have changed....also the zero range in HMI programmer may not be enough to correct the problem.
To be honest, I am uncertain how to determine where to start......I have had this problem for a while and have put off posting because i feel certain It is just a stupid mistake on my part....I am more than a little rusty
Thanks for the link ...I will try it.
i-bot:
... servo zero and initial position ..... stored ..... internal EEPROM ...... Is it these that are lost ? Or ..... servo eeprom ..... affected ?
It does seem likely that it may be the C3024 eeprom... ie it's only the code in the uController that I should have changed....also the zero range in HMI programmer may not be enough to correct the problem.
To be honest, I am uncertain how to determine where to start......I have had this problem for a while and have put off posting because i feel certain It is just a stupid mistake on my part....I am more than a little rusty
by serithseraki
Sat Jul 21, 2012 4:44 am
I am super late with the times and is there even a way for me to obtain the 2.72 update? The RoboBasic site is no longer existent. so am I out of luck? Furthermore, i-Bot, how exactly do I use your Roboflash and the binary 2.5 software to revert back to the prior version?