Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

Dead Band correction HSR-5990TG

Hitec robotics including ROBONOVA humanoid, HSR-8498HB servos, MR C-3024 Controllers and RoboBasic
2 posts • Page 1 of 1
Post a reply
2 posts • Page 1 of 1

Dead Band correction HSR-5990TG

Post by rikkov » Thu Jan 15, 2009 4:33 am

Post by rikkov
Thu Jan 15, 2009 4:33 am

Hi,

I have a doubt here....is it possible to correct the Dead Band Width of HSR-5990TG of Hitech using HFP-20 Digital Servo Programmer?.....Also can this dead band with be corrected by some other methods?

Thanks
Rikkov[/b]
Hi,

I have a doubt here....is it possible to correct the Dead Band Width of HSR-5990TG of Hitech using HFP-20 Digital Servo Programmer?.....Also can this dead band with be corrected by some other methods?

Thanks
Rikkov[/b]
rikkov
Robot Builder
Robot Builder
Posts: 15
Joined: Wed Aug 27, 2008 4:11 am
Top

Post by Tohm » Thu Jan 15, 2009 6:52 pm

Post by Tohm
Thu Jan 15, 2009 6:52 pm

The HFP-20 won't program the robotic servos. What you need to use is the HMI PC software. The robonova wiki here at Robosavvy has a link to the free software.
The HFP-20 won't program the robotic servos. What you need to use is the HMI PC software. The robonova wiki here at Robosavvy has a link to the free software.
Tohm
Savvy Roboteer
Savvy Roboteer
User avatar
Posts: 26
Joined: Tue Apr 04, 2006 1:00 am
Top

2 posts • Page 1 of 1
Post a reply
2 posts • Page 1 of 1
Return to ROBONOVA-I & Hitec