Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

servo issues...

Hitec robotics including ROBONOVA humanoid, HSR-8498HB servos, MR C-3024 Controllers and RoboBasic
2 posts • Page 1 of 1
Post a reply
2 posts • Page 1 of 1

servo issues...

Post by kong » Fri Apr 03, 2009 5:18 pm

Post by kong
Fri Apr 03, 2009 5:18 pm

Working on my RN1, i was playing with the range of how the servos move. I noticed the left and right hip servos repond different. One of the servos went "limp" at a certain point (when doing leg splits). But then recoverd when going back to original position. Dont want to replace if i dont have to. Could this be an assembly issue inside the servo, or adjust the horn mounting on servo, any recomendations would help.
Working on my RN1, i was playing with the range of how the servos move. I noticed the left and right hip servos repond different. One of the servos went "limp" at a certain point (when doing leg splits). But then recoverd when going back to original position. Dont want to replace if i dont have to. Could this be an assembly issue inside the servo, or adjust the horn mounting on servo, any recomendations would help.
kong
Robot Builder
Robot Builder
Posts: 7
Joined: Thu Mar 05, 2009 5:07 am
Top

Post by Gort » Fri Apr 03, 2009 6:56 pm

Post by Gort
Fri Apr 03, 2009 6:56 pm

Stripped gear maybe? Also check to see if you have nicked the servo wire?
Stripped gear maybe? Also check to see if you have nicked the servo wire?
Gort
Savvy Roboteer
Savvy Roboteer
User avatar
Posts: 555
Joined: Wed May 31, 2006 1:00 am
Location: KC, MO, USA
Top

2 posts • Page 1 of 1
Post a reply
2 posts • Page 1 of 1
Return to ROBONOVA-I & Hitec