Robonova 1
Robonova 1
by Cyber Samurai
Mon Jun 22, 2009 12:57 am
Need help:
1. Not sure of wiriing, left side looks ok, not sure of right side(please see photos on web link).
2. Zeroset: Attempting to correct upper leg to torso position/servos not responding. Robot default position is tilted(please see photos on web link).
3. Checked servos location/position, looks ok.
http://ptatematsu.net/remocon_pro.html
Best regards, Cyber Samurai
1. Not sure of wiriing, left side looks ok, not sure of right side(please see photos on web link).
2. Zeroset: Attempting to correct upper leg to torso position/servos not responding. Robot default position is tilted(please see photos on web link).
3. Checked servos location/position, looks ok.
http://ptatematsu.net/remocon_pro.html
Best regards, Cyber Samurai
by Gort
Mon Jun 22, 2009 3:18 pm
It looks like you have the leg servos connected to the board wrong. I have version 2.5 like you. So do what I have done. Go to the Hitec robotic website and download the update manual.
http://www.robonova.com/manager/control ... =&openWin=
The correct way to hook up servos to the controller is on page 47 or number 24 in the adobe reader.
http://www.robonova.com/manager/control ... =&openWin=
The correct way to hook up servos to the controller is on page 47 or number 24 in the adobe reader.
by Gort
Mon Jun 22, 2009 3:31 pm
Check out these posts to make sure that your screw placements coincide with the correct servo horn numbers in the legs.
http://robosavvy.com/forum/viewtopic.ph ... highlight=
http://robosavvy.com/forum/viewtopic.ph ... highlight=