Remplace jack input

[RoboJeronimo]

Hi,

I have a Robonova and I need remplace the jack data input of the board (see photo). Do you know where can I find it?

[botmen]

you can try this one ........ remove the original jack input on d board and use a standard servo lead as a replacement for the jack input.you also need to replace the one on the other end of the serial cable w a female servo lead.i encountered the same problem w the stock jack input and ended up w the male n female servo lead wc makes abetter connection than the standard one.

[botmen]

i forgot to add tahat i never encountered connection troulbe again using this setup