Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

Easy to install 6v regulator

Hitec robotics including ROBONOVA humanoid, HSR-8498HB servos, MR C-3024 Controllers and RoboBasic
16 posts • Page 2 of 2 • 1, 2
Post a reply
16 posts • Page 2 of 2 • 1, 2

Post by klims » Tue Feb 26, 2008 5:59 am

Post by klims
Tue Feb 26, 2008 5:59 am

seeing as most servos operate from 4.8-7.2v with the speed an torque characteristics varying over the voltage range, wouldn't it be beneficial to have a regulator on which the voltage could be fine tuned to get the best characteristics to suit my servos?
any feedback on this thought would be much appreciated. i would like to buy one in the next couple of days.
seeing as most servos operate from 4.8-7.2v with the speed an torque characteristics varying over the voltage range, wouldn't it be beneficial to have a regulator on which the voltage could be fine tuned to get the best characteristics to suit my servos?
any feedback on this thought would be much appreciated. i would like to buy one in the next couple of days.
klims
Newbie
Newbie
Posts: 6
Joined: Sun Feb 24, 2008 1:36 pm
Top
Previous
16 posts • Page 2 of 2 • 1, 2
Post a reply
16 posts • Page 2 of 2 • 1, 2
Return to ROBONOVA-I & Hitec