Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

Is there programing software for Mac's

Hitec robotics including ROBONOVA humanoid, HSR-8498HB servos, MR C-3024 Controllers and RoboBasic
1 post • Page 1 of 1
Post a reply
1 post • Page 1 of 1

Is there programing software for Mac's

Post by xSVxSHaDOwZ » Sat Mar 26, 2011 5:49 pm

Post by xSVxSHaDOwZ
Sat Mar 26, 2011 5:49 pm

Hello people,
I was wondering if there is any programing software for my Mac Labtop? And if there is where can I find it like a website or anything but if there is not well that just sucks.

Thanks for reading xSVxSHaDOwZ
Contact me at xSVxSHaDOwZ@yahoo.com
Hello people,
I was wondering if there is any programing software for my Mac Labtop? And if there is where can I find it like a website or anything but if there is not well that just sucks.

Thanks for reading xSVxSHaDOwZ
Contact me at xSVxSHaDOwZ@yahoo.com
xSVxSHaDOwZ
Savvy Roboteer
Savvy Roboteer
Posts: 34
Joined: Fri Mar 25, 2011 5:49 pm
Top
1 post • Page 1 of 1
Post a reply
1 post • Page 1 of 1
Return to ROBONOVA-I & Hitec