Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

needing assistance on 2-4 ghz controller

Hitec robotics including ROBONOVA humanoid, HSR-8498HB servos, MR C-3024 Controllers and RoboBasic
2 postsPage 1 of 1
2 postsPage 1 of 1

needing assistance on 2-4 ghz controller

Post by serithseraki » Tue Aug 16, 2011 6:49 pm

Post by serithseraki
Tue Aug 16, 2011 6:49 pm

I just purchased the 2.4 ghz controller for the Robonova from the active-robots site here...

http://www.active-robots.com/products/r ... ller.shtml

The controller also comes with a instruction pamphlet available as a PDF here...

http://www.active-robots.com/products/r ... 136080.pdf

Now after reading almost all of the posts in this section I am still confused by the analog control commands. I understand that "c, d, e, and f" control the different axis's and 0x00 and 0xFF are degree settings. But what does the "FF" mean? Can someone write a example code for these commands so I can get the gist of this.
I just purchased the 2.4 ghz controller for the Robonova from the active-robots site here...

http://www.active-robots.com/products/r ... ller.shtml

The controller also comes with a instruction pamphlet available as a PDF here...

http://www.active-robots.com/products/r ... 136080.pdf

Now after reading almost all of the posts in this section I am still confused by the analog control commands. I understand that "c, d, e, and f" control the different axis's and 0x00 and 0xFF are degree settings. But what does the "FF" mean? Can someone write a example code for these commands so I can get the gist of this.
serithseraki
Savvy Roboteer
Savvy Roboteer
Posts: 75
Joined: Wed Oct 21, 2009 6:31 pm

Post by serithseraki » Tue Aug 23, 2011 6:12 pm

Post by serithseraki
Tue Aug 23, 2011 6:12 pm

Apparently my links are dead. Anyway, here are new ones.

The actual controller: http://www.robonova.de/store/product.ph ... 269&page=1

The instructions: http://www.robonova.de/store/files/data ... 136080.pdf

Lastly, the new template program download for it. Note, it has nothing about the analog controls listed but if it helps you help me then why not. http://www.robonova.de/store/support/in ... &nav=0,5,7
Apparently my links are dead. Anyway, here are new ones.

The actual controller: http://www.robonova.de/store/product.ph ... 269&page=1

The instructions: http://www.robonova.de/store/files/data ... 136080.pdf

Lastly, the new template program download for it. Note, it has nothing about the analog controls listed but if it helps you help me then why not. http://www.robonova.de/store/support/in ... &nav=0,5,7
serithseraki
Savvy Roboteer
Savvy Roboteer
Posts: 75
Joined: Wed Oct 21, 2009 6:31 pm


2 postsPage 1 of 1
2 postsPage 1 of 1