Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

newbie problem

Hitec robotics including ROBONOVA humanoid, HSR-8498HB servos, MR C-3024 Controllers and RoboBasic
1 post • Page 1 of 1
Post a reply
1 post • Page 1 of 1

newbie problem

Post by Jimkidmotorsports » Mon Mar 05, 2012 7:34 pm

Post by Jimkidmotorsports
Mon Mar 05, 2012 7:34 pm

hay guys i need a way to drive a servo with a signal from a sensor that is a 0 to 5 volt refereance and that is what the sensor gives off iss 0 to 5 volts and i need to take that and drive a servo from that volt refereance thanks in advance
hay guys i need a way to drive a servo with a signal from a sensor that is a 0 to 5 volt refereance and that is what the sensor gives off iss 0 to 5 volts and i need to take that and drive a servo from that volt refereance thanks in advance
Jimkidmotorsports
Newbie
Newbie
Posts: 2
Joined: Sun Mar 04, 2012 7:59 pm
Top
1 post • Page 1 of 1
Post a reply
1 post • Page 1 of 1
Return to ROBONOVA-I & Hitec