Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

HSR-8498 lock up

Hitec robotics including ROBONOVA humanoid, HSR-8498HB servos, MR C-3024 Controllers and RoboBasic
16 posts • Page 2 of 2 • 1, 2
Post a reply
16 posts • Page 2 of 2 • 1, 2

Post by serithseraki » Sun May 27, 2012 11:25 pm

Post by serithseraki
Sun May 27, 2012 11:25 pm

Another update: After cleaning the grease residue from the casing in the hole where the gear axle sits I put the servo back together with clean gears that I sprayed the CRC brand white lithium aerosol on. When turning the MRC3000 on and testing the servo with the servo manager it responded almost perfectly, the only problem was with changing direction at the slowest speed but that was within normal parameters. So now I will do the same with the other servos and hopefully get some play out of my Nova while waiting to accumulate funds for fresh servos. I hope anyone who reads this topic will find the information to be helpful for keeping your Nova's alive longer.
Another update: After cleaning the grease residue from the casing in the hole where the gear axle sits I put the servo back together with clean gears that I sprayed the CRC brand white lithium aerosol on. When turning the MRC3000 on and testing the servo with the servo manager it responded almost perfectly, the only problem was with changing direction at the slowest speed but that was within normal parameters. So now I will do the same with the other servos and hopefully get some play out of my Nova while waiting to accumulate funds for fresh servos. I hope anyone who reads this topic will find the information to be helpful for keeping your Nova's alive longer.
serithseraki
Savvy Roboteer
Savvy Roboteer
Posts: 75
Joined: Wed Oct 21, 2009 6:31 pm
Top
Previous
16 posts • Page 2 of 2 • 1, 2
Post a reply
16 posts • Page 2 of 2 • 1, 2
Return to ROBONOVA-I & Hitec