Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

Replacement micro motor

Hitec robotics including ROBONOVA humanoid, HSR-8498HB servos, MR C-3024 Controllers and RoboBasic
1 post • Page 1 of 1
Post a reply
1 post • Page 1 of 1

Replacement micro motor

Post by serithseraki » Tue Dec 11, 2012 3:29 am

Post by serithseraki
Tue Dec 11, 2012 3:29 am

I opened up another HSR-8498HB and found that there was an id code on the micro motor stating "motorbank 14200" I looked it up and found this company that apparently made the motor http://www.motorbank.co.kr/ although the motor seems to have been discontinued. Now seeing as my knowledge on electronics is limited can someone provide me with a thorough specification of the DC micro inside the servo so I can find a possible replacement?
I opened up another HSR-8498HB and found that there was an id code on the micro motor stating "motorbank 14200" I looked it up and found this company that apparently made the motor http://www.motorbank.co.kr/ although the motor seems to have been discontinued. Now seeing as my knowledge on electronics is limited can someone provide me with a thorough specification of the DC micro inside the servo so I can find a possible replacement?
serithseraki
Savvy Roboteer
Savvy Roboteer
Posts: 75
Joined: Wed Oct 21, 2009 6:31 pm
Top
1 post • Page 1 of 1
Post a reply
1 post • Page 1 of 1
Return to ROBONOVA-I & Hitec