Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

Controller Pinout?

Hitec robotics including ROBONOVA humanoid, HSR-8498HB servos, MR C-3024 Controllers and RoboBasic
3 posts • Page 1 of 1
Post a reply
3 posts • Page 1 of 1

Controller Pinout?

Post by Richard » Sat Jan 06, 2007 2:14 pm

Post by Richard
Sat Jan 06, 2007 2:14 pm

Is there a full pinout diagram of RoboNova's controller connectors anywhere?
Is there a full pinout diagram of RoboNova's controller connectors anywhere?
Richard
Robot Builder
Robot Builder
User avatar
Posts: 21
Joined: Mon Apr 10, 2006 1:00 am
Top

Post by TheGuru » Sat Jan 06, 2007 3:02 pm

Post by TheGuru
Sat Jan 06, 2007 3:02 pm

Hi Richard,

If you mean the standard servo, pwm, ad etc pinouts then there are two versions depending on which one you have. I found this with mine when the provided manual didn't match the board but a downloaded more recent PDF did. Both appear on page 42 of the manuals. I've attached both below.
ImageImage

Regards

Mark
Hi Richard,

If you mean the standard servo, pwm, ad etc pinouts then there are two versions depending on which one you have. I found this with mine when the provided manual didn't match the board but a downloaded more recent PDF did. Both appear on page 42 of the manuals. I've attached both below.
ImageImage

Regards

Mark
Never criticise a man until you've walked a mile in his shoes ... then you can say what you want cos he's a mile away and you have his shoes ;o)
TheGuru
Robot Builder
Robot Builder
User avatar
Posts: 10
Joined: Sun Dec 17, 2006 1:00 am
Location: Coventry, UK
Top

Post by Richard » Sun Jan 07, 2007 11:06 am

Post by Richard
Sun Jan 07, 2007 11:06 am

You're right it is in the manual! Couldn't see the wood for the trees! :roll:
You're right it is in the manual! Couldn't see the wood for the trees! :roll:
Richard
Robot Builder
Robot Builder
User avatar
Posts: 21
Joined: Mon Apr 10, 2006 1:00 am
Top

3 posts • Page 1 of 1
Post a reply
3 posts • Page 1 of 1
Return to ROBONOVA-I & Hitec