After Main Template?

[Humanoido]

I loaded in the main template and everything works. So now if I want to add my own program, such as situps, should I add it to the template as additional code or make it into a program of its own without the template?

The manual is very confusing at this point. Can anyone write some very simple instructions about what to do at this point? I'm sure there are many here that can benefit from some help. Thanks.

Humanoido

[crosswede]

Hello,
you can place it in or 'middle between' the overall_template.bas-code. Only you have to do is at the begin of the listing to reserve some buttons of the remotecontrol to start your own sequencies. There is a very good example by bauermech with nice coments to do this in the thread of 'kungfu-code' in this forum. ( http://robosavvy.com/modules.php?name=F ... ght=kungfu). Sure better to read there than try to translate my real cruel english. Reading and speaking is always well again, but writing has so long time ago that its became a real special slang.

greets
Bert

[DirtyRoboto]

Or you can...
Load any of the single move templates i.e. "4_Sit Down and Raise Hands(Version 1.00 20051115).bas"
and paste your routine over the existing routine and save it under a new name.

Marcus.